FANUC 0i-TF S890: check axis IDs across paths when G51.4 raises PS5339
P and Q refer to function-specific axis IDs, not axis names. Duplicate IDs across paths can trigger PS5339.
Contents
P and Q refer to function-specific axis IDs, not axis names. Duplicate IDs across paths can trigger PS5339.
The option and its commands
FANUC lists A02B-0339-S890 for programmed synchronous, composite and superimposed control on the 0i-TF (not Plus). This article covers feed-axis synchronization: G51.4 P_ Q_ (L_) starts it, and G50.4 Q_ cancels it. P identifies the master feed axis and Q the slave; neither is a spindle speed command. L is optional. A minimum CNC software release was not verified. The feed-axis synchronization described here also requires the corresponding Synchronous and Composite Control option.
PS5339: cross-check each path without changing it
The parameter manual identifies 12600 as the source of the IDs used by P and Q. An axis with ID 0 cannot take part in this programmed control. A duplicate nonzero ID on two axes can trigger PS5339 in a related command block even when those axes belong to different paths. If a backup shows ID 7 on an axis in each path, looking at the alarmed path alone misses the conflict. Keep the alarm block, path and full display, then compare the existing 12600 entries with the builder’s axis list. Do not force PMC signals or change IDs to test.
Entitlement is not axis configuration
PS5339 does not establish that S890 is missing. No dedicated missing-option alarm or exact PS5339 screen wording was verified for 0i-TF. Give FANUC or the builder the serial number, CNC software version, installed options and axis configuration to confirm ordering eligibility, prerequisites and commissioning. The operator’s manual describes PS0010 (IMPROPER G-CODE) as a general alarm when a G code is unlisted or lacks its corresponding option. Check the entire block and option record.
References
- FANUC CNC Function Catalogue (2024) (p. 051)
- FANUC B-64610EN/01 (§4.102, p. 605, No. 12600)
- FANUC B-64602EN/01 (§5.48, p. 196)
- FANUC B-64604EN-1/01 (p. 12; Appendix A, 12600)