FANUC 31i-B J398/J399: G05.4, diagnostic 700 and SV0468
SV0468 detail 10133 points to amplifier compatibility. Diagnosis 700 separates availability from active control.
Contents
G05.4 is not G05.1
FANUC lists high-speed HRV3 as A02B-0327-J398 and high-speed HRV4 as A02B-0327-J399 for the non-Plus 31i-B. G05.4 Q1/Q0 starts or cancels high-speed HRV current control during cutting feed. It is not G05.1 contour control. The manual commands them separately; acceptance of one does not establish availability of the other.
Section 1.1 of the servo manual lists 31i-B under servo software 90G0/03.0 and later. This is a servo software scope, not a minimum CNC release or proof of amplifier compatibility.
Read diagnostic 700
The servo manual identifies 700#1 (HOK) as availability and 700#0 (HON) as active high-speed current control. With HOK set, observe HON during a cutting-feed move inside G05.4 Q1. On applicable HRV3 configurations only, if the builder has enabled 2283#0 (NOG54), G01 cutting feed does not need Q1. This exception does not apply to HRV4. A reading taken only during rapid traverse is not enough to diagnose a fault.
SV0468 detail 10133
The servo manual maps detail 10133 to alarm 468 (HI HRV SETTING ERROR(AMP)): the axis is configured for HRV3 or HRV4, but its amplifier does not support that control type. This is a servo setup and hardware compatibility alarm, not one directly triggered by executing G05.4. If only one axis reports this after a replacement, compare its full amplifier part number, servo software and original machine configuration. Do not apply this diagnosis to other details. The cited sources do not establish a dedicated missing-option alarm.
Verify entitlement and hardware separately
Give FANUC or the machine builder the CNC, amplifier and servo card specifications, software revisions, installed options and alarm axis. Have authorized service confirm the supported combination and upgrade path. Do not change servo parameters or control cycles just to clear the alarm.
References
- FANUC CNC Function Catalogue · p. 102 (J398), p. 104 (J399), High-Speed HRV
- FANUC Servo Parameter Manual B-65270EN/08 · §1.1, p. 1; pp. 59–60, 147; §5.1.2, p. 180; §5.1.5, pp. 185–186