FANUC 31i-B J919: why G54.1 P48 works but P49 can raise PS0030
Separate 300-pair option entitlement, P-number limits and offset data before diagnosing PS0030.
Contents
If G54.1 P48 is accepted but G54.1 P49 alarms in the same program, first check the available offset range. Do not immediately blame the decimal point or change option parameters. Support for 48 additional systems does not establish support for 300.
Which option this article covers
The 2013 FANUC function catalogue, printed p.226, lists A02B-0327-J919, 31i-B Workpiece Coordinate, 300 Pairs. These are 300 additional systems beyond G54–G59, not 300 including the six standard systems. Operation here follows B-64484EN/03, §7.2.5, printed pp.165–166, for 31i-B. Do not transfer standard configurations from 0i, B Plus or other software. /03 identifies the manual revision, not a minimum software version.
Before adding the option, supply FANUC or the original machine builder with the complete control model, serial number, software series/version and existing option list. Have them confirm J919 compatibility and entitlement, its relationship to the current configuration and backup requirements, then use their installation and acceptance process. No machine-specific installation procedure was obtained; no unlocking bits or option files are provided. Entitlement, configuration and correct offset values are separate matters.
What a P49 alarm establishes
The manual specifies PS0030 when P after G54.1 exceeds the permitted range; the same manual also uses the title ILLEGAL OFFSET NUMBER. On a system confirmed to have 48 additional systems but not the 300-system configuration, P49 is out of range: this is a direct application of that rule. It does not mean every missing-option condition produces PS0030, nor does this alarm alone prove that J919 is absent.
Even with a confirmed working 300-system configuration, P301 remains outside the range. A mistyped or incorrectly postprocessed number can trigger the same rule. Preserve the complete alarm block and text, then check the manufacturer-confirmed capacity, actual P value and offset table. Do not test arbitrary P values on the machine.
Selecting and writing are different operations
G54.1 P49; selects additional system 49; it does not measure or populate its offset. G10 L20 P49 IP_; is the manual's offset-writing format. IP_ represents axis addresses and values, not literal executable text. Absolute input replaces the old value; incremental input adds to it. Verify the actual mode and units and preserve the original data before use.
As an arithmetic illustration only, an old value of 100.000 and input of 2.000 yield 2.000 by replacement or 102.000 by addition. These are not recommended machine settings; they show why the number in a G10 block alone does not determine the final offset. A selected coordinate system remains effective until another is selected. Within this manual's scope, power-on selects standard G54.
Two syntax details worth checking
In this edition, G54.1 without P in the same block assumes P1. No alarm therefore does not prove selection of the intended fixture. Do not put a dwell or subprogram P address in the same G54.1 block: the manual prohibits P values serving another purpose there. Separate G54.1 from G04 P1000 or M98 P48 and recheck the meaning rather than treating their P addresses as independent.
Validate the data and the complete path
With the machine stopped, check licensed capacity, fixture numbering, each axis offset and its measurement source. Then inspect the actual selection and all subsequent motion. Newly available systems may have no usable offset data. Acceptance of a command does not establish fixture, tool or travel safety. Use the builder's approved validation method, retain an untouched backup and a change record, and do not equate alarm clearance with acceptance. This is a manual-based analysis, not a claimed repair case.
Sources
Both links are third-party mirrors of manufacturer documents; use the matching edition and machine-builder confirmation.