Independent CNC repair and technical reference Contact

FANUC 31i-B S667: why G41.3 can raise PS5408 at startup

Published Updated

Check the move after G41.3, machine kinematics and authorization before confusing startup geometry with a missing option.

Contents
  1. S667 is not ordinary planar compensation
  2. Identify the machine first
  3. A coordinate-free startup block can still move
  4. Use the alarm to narrow the check
  5. A missing option has no verified one-to-one alarm here
  6. Authorized addition and validation

S667 is not ordinary planar compensation

The 2024 FANUC catalogue lists A02B-0327-S667 for 31i-B three-dimensional cutter compensation. It supports five-axis surface programming with tool-size adjustment at the control. This article concerns its G41.3 leading-edge offset, not the separate G41-with-IJK three-dimensional tool compensation.[1][2]

Identify the machine first

B-64484EN/03 places leading-edge offset under tool-rotation machines. Having five axes does not establish suitability; do not transfer it directly to table-rotation or mixed machines. Its offset direction depends on tool orientation and motion, rather than ordinary two-dimensional left/right geometry.[2]

A coordinate-free startup block can still move

The documented forms are G41.3 D_ and G40 for cancellation. Start in G00/G01 mode; startup/cancel blocks exclude motion commands and allow only D, O and N as additional addresses. The next block must move, but not along or opposite the tool axis at startup. Crucially, G41.3 establishes an offset displacement and G40 removes it: no XYZ words does not mean no movement.[2]

Use the alarm to narrow the check

PS5408 concerns an unsuitable startup mode or a tool/motion angle classified as 0° or 180°; the manual includes an angular classification range, not just exact mathematical parallelism. For PS5406, check motion in the startup/cancel block and buffering-suppressing codes at startup. For PS5460, check G41.3 on a machine other than the tool-rotation type, plus illegal modes or command combinations.[2][3]

A missing option has no verified one-to-one alarm here

The reviewed sources do not establish one alarm that uniquely means S667 is absent. PS0010 generally identifies an unusable G code; it alone does not prove missing S667. Preserve the rejected block, adjacent blocks and modes, then compare installed options instead of immediately buying an option or changing machine-configuration parameters.[3]

Authorized addition and validation

Scope is 31i-B and the cited editions; minimum software revision is unverified and Plus is not covered. Give FANUC or the builder the system/software version, kinematics, option record and target program to confirm S667 and dependencies through their authorized addition process. Configuration is not licensing. Review postprocessor startup geometry and compensation travel offline, then arrange controlled acceptance by qualified personnel under builder procedures. This is not an executable program or a machine-tested result.

PS5408: G41.3 ILLEGAL START_UP
PS5406: G41.3/G40 FORMAT ERROR
PS5460: ILLEGAL USE OF 3-DIMENSIONAL CUTTER COMPENSATION
PS0010: IMPROPER G-CODE

Related technical articles

FANUC 31i-B J853 orientation: distinguish yellow status code 05 from a spindle alarmFANUC 31i-B J852 Cs contour control: does PS0303 mean an option is missing?FANUC 31i-B J777: why an accepted G05.1 Q2 does not mean every block is smoothed