Independent CNC repair and technical reference Contact

FANUC 0i-F Plus Type 3: How to check R522 and G68.2 support

Published Updated

Both FANUC tables list Type 3 M as optional. They disagree on Type 3 T, so verify the actual machine.

Contents
  1. Start with the Type 3 M or T column
  2. G68.2 and the guidance screen are separate
  3. Read the block that raised PS0010
  4. Confirm the option through the authorized provider
  5. References

Start with the Type 3 M or T column

The R522 row on page 15 of FANUC B-64692EN/01 marks Type 3 M optional and Type 3 T unavailable. The FANUC TMN21-282E (SpecE)-04 table marks both Type 3 M and T optional. These documents disagree; neither establishes a universal rule for Type 3 T. The catalog lists A02B-0350-R522 for 0i-MF Plus and A02B-0349-R522 for 0i-TF Plus. A series-level order number does not confirm eligibility for a particular machine.

G68.2 and the guidance screen are separate

G68.2 defines a tilted feature coordinate system; G69 cancels it. The R522 entry in B-64692EN/01 says that the guidance screen is not shown on an 8.4-inch LCD. This note does not establish that a factory 8.4-inch Type 3 configuration exists. On a machine confirmed to have R522, the missing screen alone is not evidence that the function is unavailable. Conversely, a visible screen does not validate the program path or machine motion configuration. This is a selection and diagnostic guide, not a G68.2 P1 angle-order or 3+2 programming tutorial.

Read the block that raised PS0010

B-64694EN/01 documents PS0010 (IMPROPER G-CODE) for an unlisted G code or a missing corresponding option. If the alarm occurs on G68.2, capture the full alarm and block, then check the actual M/T control, path and G-code table for that software release. PS0010 alone does not establish missing R522 entitlement. The cited 8.4-inch note concerns the guidance display only, not PS0010.

Confirm the option through the authorized provider

Give FANUC or the machine builder the machine serial number, complete CNC model, Type and M/T designation, software series and release, display size, installed options and rotary-axis configuration. The public documents do not establish a universal minimum release. Have authorized service confirm eligibility and carry out commissioning under the builder’s procedure. Do not change parameters or run a motion command just to test entitlement.

References

Related technical articles

FANUC 31i-B5 S996: the two I/J/K triplets in G43.9 and alarm PS5464FANUC 31i-B J708: use diagnosis 471 to narrow down PS0218FANUC 31i-B J398/J399: G05.4, diagnostic 700 and SV0468