Independent CNC repair and technical reference Contact

FANUC 31i-B J708: use diagnosis 471 to narrow down PS0218

Published Updated

The PS0218 label mentions P/Q. Diagnosis 471 separates omitted words, invalid values and a negative Q that conflicts with the configured direction rule.

Contents
  1. Identify which polygon-turning feature is installed
  2. Capture diagnosis 471 before resetting the alarm
  3. Separate code availability, block layout and hardware
  4. Sources

The PS0218 label mentions P/Q. Diagnosis 471 separates omitted words, invalid values and a negative Q that conflicts with the configured direction rule.

Identify which polygon-turning feature is installed

FANUC lists A02B-0327-J708 for Polygon Turning with Two Spindles on the non-Plus 31i-B. It synchronizes a workpiece master spindle and a tool spindle at a speed ratio. B-64482EN/03 §3.32 calls for at least two serial spindles. This differs from J817 polygon turning, where a servo axis turns the tool. Having two spindles or a control that accepts G51.2 does not prove J708 entitlement. This article covers the non-Plus 31i-B lathe; a minimum CNC software revision was not verified. Give FANUC or the machine builder the machine serial number, software series and revision, option record and spindle configuration so authorized service can verify compatibility, activation and acceptance.

Capture diagnosis 471 before resetting the alarm

G51.2 engages polygon synchronization; G50.2 cancels it. In this configuration P/Q specify the ratio, and R is for phase difference. For PS0218 (NOT FOUND P/Q COMMAND), record the complete block and diagnosis 471 before reset, while the relevant cause bits are retained. Bit 7 NPQ means R was specified without either P or Q, or all three words were omitted. Bit 6 PQE means P or Q is out of range or the pair is incomplete. Bit 5 QMS means the program specifies a negative Q while existing 7603 bit 1 (QDR) is 1. Compare an offline program copy with the documented configuration rather than changing direction parameters to test it.

Separate code availability, block layout and hardware

PS0010 (IMPROPER G-CODE) can mean a code is unsupported or its corresponding option is unavailable; it does not isolate J708. For PS0219 (COMMAND G51.2/G50.2 INDEPENDENTLY), look for other commands in the start or cancel block. If PS0314 (ILLEGAL SETTING OF POLYGONAL AXIS) appears with diagnosis 471 bit 4 (NSP) set, check whether the required serial spindles are present and connected and whether their assigned roles match the machine documentation. Do not assume changing P/Q addresses that condition. Give recorded findings to the builder instead of running a new motion test.

Sources

Related technical articles

FANUC 0i-F Plus Type 3: How to check R522 and G68.2 supportFANUC 31i-B5 S996: the two I/J/K triplets in G43.9 and alarm PS5464FANUC 31i-B J398/J399: G05.4, diagnostic 700 and SV0468