FANUC 31i-B J891: why can G62 run without slowing an inner corner?
A rejected G62 and an accepted G62 with no expected slowdown require different checks: compensation, corner conditions and the override range.
Contents
Rejection and lack of effect are different symptoms
Do not order an option simply because the speed seems unchanged at an inner corner. Preserve the complete alarm, surrounding blocks, modal display, offset number and value. A command rejected during interpretation calls for a different investigation from an accepted command whose machining effect is unexpected.
Identify the system behind J891
FANUC’s 2013 catalogue identifies A02B-0327-J891 as automatic corner override for 31i-B. The 31i-B order code must not be assumed to apply to other systems. This article concerns the 31i-B machining-center system using B-64484EN/03 and B-64484EN-2/03. Manual editions are not minimum software revisions; the latter was not verified.
Before installation, have FANUC or the builder check the model, serial number, software series/revision and existing authorization, confirm compatibility, and carry out its installation and acceptance procedure. No unverified installation steps are supplied. A related parameter in the table does not establish licensing, and changing an override parameter does not grant a license.
G62 is conditional, not a universal corner slowdown
G62 selects inner-corner override in cutter-radius compensation; G61, G63 or G64 replaces that mode. The manual also treats internal circular feedrate change in its automatic-corner-override chapter. That action does not require G62 in compensation mode, so a slower arc does not prove that G62 inner-corner override is active.
For read-only checks, 1711 defines the corner angle, 1712 the override, and 1713/1714 the distances before/after the corner. Compare them with the tool-center path, not just the part contour. Inner-corner override is absent with zero compensation, a preceding compensation start-up block, or a following G41/G42 block; the manual also restricts it during acceleration/deceleration before interpolation.
Alarm evidence and a diagnostic scenario
The series’ G-code rules associate PS0010 (IMPROPER G-CODE) with a missing corresponding option or a code outside the applicable table. It is not a J891-specific alarm. Check the actual rejected code and system before checking authorization; PS0010 alone is not a reason to buy the option.
Suppose an unchanged program stops slowing at inner corners after a tool change, without an alarm. This is an analytical example, not a repair report. Compare the offsets and compensation-entry blocks first. A newly zero offset supplies an explanation unrelated to licensing. Do not enlarge compensation or change overrides merely to test that guess. Qualified personnel should verify the path, fixture clearance and stopping arrangements under the builder’s procedure before testing, retaining before/after records.
Sources and limits
The catalogue and manuals are third-party mirrors of FANUC documents. No machine test was performed. No universal parameter settings or executable coordinate program are supplied.